$15 · USB To RS232 TTL UART PL2303HX Auto Converter USB to COM Module Cable

USB To RS232 TTL UART PL2303HX Auto Converter USB to COM Module Cable -Brand new and high quality -Supports baud rate from 75 to 128000 -Support Linux, Mac OS, WinCE and Windows (XP, Vista Win 7 inc 64 Bit Edition) -Chip set: PL2303HX -USB to Serial Controller adopted -4 connecting wires, 2.54mm pitch type -Red Wire == VCC, (+5V) -Black Wire ==GND -Green Wire == TXD -White Wire == RXD -Length: Approx 1M -Ideal for Raspberry Pi/ and other hobby prototyping -The cable is easiest way to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36t; - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets. Because of the separated pin plugs, this cable is ideal for powering and connecting to the debug/login console on the Raspberry Pi. Connect the pins to power the Pi and establish the RX/TX link. Then install the Windows XP/Vista/7 or MacOS X PL2303HX.A drivers on your computer and connect with a terminal program at 115200 baud. Windows 8 is not supported. Also handy for hacking WiFi routers to install alternate OS's, or nearly any other TTL port. This is easier to use than an FTDI cable in many cases because the wires are separated. This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence. - We specialize in Electronics, Computer, Cell Phone Accessories, Professional Signal Conversion Devices, Adapter & Cables Pickup Location: "Cable Link" Tel: 613-680-6188